hi guys,
i bought single axis gyrometer analog output cytron technologies.
it :
powered +5v onboard 3.3v voltage regulator.
raw sensitivity: 0.67mv/°/s
full scale range: 300°/s
onboard amplifier. gain: 4.7x
i looked while sample code online , how connect sensor arduino mega. after many hours of research, still can't find right program , how can connect gyrometer.
appreciate if guys can me on sharing simple code new please kind , offer advice may have.
thank you.
i bought single axis gyrometer analog output cytron technologies.
it :
powered +5v onboard 3.3v voltage regulator.
raw sensitivity: 0.67mv/°/s
full scale range: 300°/s
onboard amplifier. gain: 4.7x
i looked while sample code online , how connect sensor arduino mega. after many hours of research, still can't find right program , how can connect gyrometer.
appreciate if guys can me on sharing simple code new please kind , offer advice may have.
thank you.
the schematic isn't 100%. there undefined "reference voltage". (maybe 3.3v/2)
connect arduino's 5v , gnd. 2 outputs a0 , a1.
loop : read analog values - print them. when sensor still. hope both a0 , a1 values ar close 335.
when rotating 1 value change litte, other value change more ? (but still litte)
it shoud possible change analogread raw value 200 1 rev/sec
can u determine range of values read? .. , voltage on pin 3 of op-amp?
connect arduino's 5v , gnd. 2 outputs a0 , a1.
loop : read analog values - print them. when sensor still. hope both a0 , a1 values ar close 335.
when rotating 1 value change litte, other value change more ? (but still litte)
it shoud possible change analogread raw value 200 1 rev/sec
can u determine range of values read? .. , voltage on pin 3 of op-amp?
Arduino Forum > Using Arduino > Sensors > Single Axis Gyro SN-ENC03R with ARDUINO MEGA Problem
arduino
Comments
Post a Comment