is schematic correct sample discussed here:
http://forum.arduino.cc/index.php?topic=223286.0
http://forum.arduino.cc/index.php?topic=223286.0
no.
now that's clear answer question, let me guess know why not, though did not ask that.
the sketch watches pin 10 see button being pressed or not.
it decides either light led on pin 7, or not.
you have nothing connected pin 10, , if had, you'd have press 2 buttons @ same time led lit.
the sketch tells use 470 ohms resistors, using 220 ohms.
do have reason deviate instructions ?
do have 3 volt servo allows 5 volt logic control ?
next time drawing schematics,, try avoid diagonal lines.
and sure not draw lines cross components.
now that's clear answer question, let me guess know why not, though did not ask that.
the sketch watches pin 10 see button being pressed or not.
it decides either light led on pin 7, or not.
you have nothing connected pin 10, , if had, you'd have press 2 buttons @ same time led lit.
the sketch tells use 470 ohms resistors, using 220 ohms.
do have reason deviate instructions ?
do have 3 volt servo allows 5 volt logic control ?
next time drawing schematics,, try avoid diagonal lines.
and sure not draw lines cross components.
Arduino Forum > Using Arduino > General Electronics > Several Things At The Same Time Schematic
arduino
Comments
Post a Comment