Arduino Fingerprint Servo code

hi name yair , im working on lock thats based off fingerprint sensor. coded dont know if correct, can please proofread it? thank much!


this sketch attempt identify enrolled fingerprint.
*/

#include "fps_gt511c3.h"
#include "softwareserial.h"
#include <servo.h>

// hardware setup - fps connected to:
//  digital pin 4(arduino rx, fps tx)
//  digital pin 5(arduino tx - 560ohm resistor fps tx - 1000ohm resistor - ground)
//this brings 5v tx line down 3.2v dont fry our fps
servo myservo;
fps_gt511c3 fps(4, 5);

void setup()
{
serial.begin(9600);
delay(100);
fps.open();
fps.setled(true);
pinmode(11, output);
pinmode(12, output);
myservo.attach(13);
}

void loop()
{
if (fps.ispressfinger())
{
fps.capturefinger(false);
int id = fps.identify1_n();
if (id <200)
{
serial.print("welcome master: ");
serial.println(id);
digitalwrite(11, high);
delay(2000);
digitalwrite(11, low);



}
else
{
serial.println("finger not found");
digitalwrite(12, high);
delay(2000);
digitalwrite(12, low);
myservo.write(0);
}
}
else
{
serial.println("please press finger");
}


delay(100);
}

i left out:


this sketch attempt identify enrolled fingerprint.
*/

#include "fps_gt511c3.h"
#include "softwareserial.h"
#include <servo.h>

// hardware setup - fps connected to:
//  digital pin 4(arduino rx, fps tx)
//  digital pin 5(arduino tx - 560ohm resistor fps tx - 1000ohm resistor - ground)
//this brings 5v tx line down 3.2v dont fry our fps
servo myservo;
fps_gt511c3 fps(4, 5);

void setup()
{
serial.begin(9600);
delay(100);
fps.open();
fps.setled(true);
pinmode(11, output);
pinmode(12, output);
myservo.attach(13);
}

void loop()
{
if (fps.ispressfinger())
{
fps.capturefinger(false);
int id = fps.identify1_n();
if (id <200)
{
serial.print("welcome master: ");
serial.println(id);
myservo.write(180);
digitalwrite(11, high);
delay(2000);
digitalwrite(11, low);



}
else
{
serial.println("finger not found");
digitalwrite(12, high);
delay(2000);
digitalwrite(12, low);
myservo.write(0);
}
}
else
{
serial.println("please press finger");
}


delay(100);
}

Arduino Forum > Using Arduino > Programming Questions > Arduino Fingerprint Servo code

arduino